Fibocom MG661-EU - ESD Indicators

5 Reliability
62
Test Item
Test Condition
Sweep frequency: 0.5 Octave/min, linear;
Each axis: 2H;
Salt spray
Neutral salt spray, 48H
5.3 ESD Indicators
The module is ESD sensitive component, and the ability to resist static electricity is weak. So
ESD precautions that apply to ESD sensitive components should be strictly followed. Proper
ESD procedures must be applied throughout the processing, delivery, assembly and
operation.
The ESD allowable discharge range of the module is as follows (temperature: 25°C, relative
humidity: 40 %):
Table 37. ESD indicators
Test Point
Air Discharge (kV)
Contact Discharge (kV)
Antenna ground
±15KV
±8
Antenna core
- -
±8
The data is tested based on the MG661 development board.