8 Packaging and Production
71
Figure 36. Tape packaging process
Description:
1. Place a module into the carrier tape slot in sequence according to the specified direction,
and seal the heat sealing film.
2. Place the specified number of module tapes, as shown in the following figure.
3. Before vacuumizing, place 3 bags of drying agent and a humidity card above the tape, and
paste the carrier tape label.
4. Put the whole into a vacuum bag and vacuumizing.
5. The vacuum electrostatic bag is put into a tape white box, and only one electrostatic bag
is put into a single white box. Buckle the white box and paste a label.
6. Seal the bottom of the outer box, and put the 4 pcs white boxes into the outer box as shown
in the figure.
To Next Page
Loading...
