Change History
78
FCC Conformance information
Important Notice to OEM integrators
1. This module is limited to OEM installation ONLY.
2. This module is limited to installation in mobile applications, according to Part 2.1091(b).
3. The separate approval is required for all other operating configurations, including portable
configurations with respect to Part 2.1093 and different antenna configurations
4. For FCC Part 15.31 (h) and (k): The host manufacturer is responsible for additional testing
to verify compliance as a composite system. When testing the host device for compliance
with Part15 Subpart B, the host manufacturer is required to show compliance with Part 15
Subpart B while the transmitter module(s) are installed and operating. The modules should
be transmitting and the evaluation should confirm that the module's intentional emissions are
compliant (i.e. fundamental and out of band emissions). The host manufacturer must verify
that there are no additional unintentional emissions other than what is permitted in Part 15
Subpart B or emissions are complaint with the transmitter(s) rule(s).
The Grantee will provide guidance to the host manufacturer for Part 15 B requirements if
needed.
Important Note
notice that any deviation(s) from the defined parameters of the antenna trace, as described
by the
instructions, require that the host product manufacturer must notify to Fibocom Wireless Inc.
that they wish to change the antenna trace design. In this case, a Class II permissive change
application is required to be filed by the USI, or the host manufacturer can take responsibility
through the change in FCC ID (new application) procedure followed by a Class II permissive
change application.
End Product Labeling
When the module is installed in the host device, the FCC ID label must be visible through a
To Next Page
