D4, Database User Name and Password
(These two settings are not necessary if you don’t use the “Database” or the “Control Command
Password=Disable” on LS-20.)
Device Database:
Please refer to the “6. Device Name Data Base Management”.
User can assign a device name to each sensor/controller. When the Event Log, Device Status or Special
Sensor Reading are recalled, the software will match the “User Name/ Device Type/ Zone Number”
under in the Data Base and show the corresponding device name on the table.
Password:
If the setting of the LS-20 Base Unit “ Control Command Password = Enable” then you should enter
the passwords.
To Next Page
Loading...