First Light C-RED 3 - Page 58

58
agc roi Get ROI for AGC
agc priority
Get priority when underexposed and overexposed
pixels are present in medium gain
tuning
Get current camera tuning (FW 1.1.0 or above)
date Get current date/time (FW 1.3.0 or above)
ping <address>
Pings the specified address (FW 1.3.0 or above)
uptime Returns the uptime (amount of time since boot) (FW
1.3.0 or above)
accumulateduptime
Returns the accumulated uptime of the camera
(accumulated uptime since installation of firmware
monitoring uptimes) (FW 1.3.0)
totaluptime Returns the total uptime of the camera since its
manufacturing (FW 1.3.0). Only valid for newly
manufactured cameras
exec upgradefirmware <url> Upgrade the firmware with a new release located at
the specified URL
exec uploadfirmware
Upgrade the firmware
exec buildbias Build the bias correction image
exec buildflat
Build the flat correction image
exec buildflat hdr_c1 Build the flat correction image to be used with C1
capacitor in HDR mode
exec buildflat hdr_c2
Build the flat correction image to be used with C2
capacitor in HDR mode
exec dellicense <license> Delete a license file. Will be active on next reboot
exec enablelicense <license>
Activates a license file. Will be active on next reboot
exec disablelicense <licence> Deactivates a license file. Will be active on next reboot
exec logs
Collect and serve logs through http
exec logs <from> Collect and serve logs through http
exec httpserver start
Starts the embedded http server (FW 1.3.0 or above)
exec httpserver stop Stops the embedded http server (FW 1.3.0 or above)
exec ethernetgrabber start
Starts the TCP server used to grab image (FW 1.3.0 or
above)
exec ethernetgrabber stop
Stops the TCP server (FW 1.3.0 or above)
buildnuc bias <nbframes> Build the bias correction image (asynchronous) (FW
1.1.0 or above)
buildnuc flat <nbframes>
Build the flat correction image (asynchronous) (FW
1.1.0 or above)
buildnuc flat_hdr_c1 <nbframes> Build the flat correction image to be used in with
HDR/C1 (FW 1.1.0 or above)
buildnuc flat_hdr_c2 <nbframes>
Build the flat correction image to be used in with
HDR/C2 (FW 1.1.0 or above)
buildnuc progress Returns the estimated remaining time in seconds (FW
1.1.0 or above)
buildnuc abort Aborts the computation (FW 1.1.0 or above)
set imagepattern ramp
Enable transmission of ramp image instead of sensor
image (FW 1.3.0 or above)