First Light C-RED 3 - Page 59

59
set imagepattern constant <value> Enable transmission of a constant image instead of
sensor image (FW 1.3.0 or above)
set imagepattern off
Disable image pattern transmission (FW 1.3.0 or
above)
set voltage vref <vrefValue> Set VREF voltage (V)
set temperatures snake <snakeValue>
Set sensor temperature setpoint (°C)
set fps <fpsValue> Set acquisition framerate (Hz)
set tint <intValue>
Set integration time (s)
set tintgranularity on Enable exposure time granularity in IWR mode
set tintgranularity off
Disable exposure time granularity in IWR mode
set tcdsadjust on Enable TCDS value adjustment for small integration
times
set tcdsadjust off
Disable TCDS value adjustment for small integration
times
set vrefadjust on Enable VREF value adjustment
set vrefadjust off Disable VREF value adjustment
set bias on Enable bias correction
set bias off
Disable bias correction
set adaptbias on Enable adaptative bias
set adaptbias off
Disable adaptative bias
set flat on Enable flat correction
set flat off Disable flat correction
set badpixel on Enable bad pixel correction
set badpixel off
Disable bad pixel correction
set imagetags on Enable tags generation
set imagetags off
Disable tags generation
set led on Turn on the status led
set led off Turn off the status led
set events on Enable camera events
set events off
Disable camera events
set extsynchro on Enable external synchronization
set extsynchro off
Disable external synchronization
set extsynchro polarity standard Selects standard synchronization signal polarity
set extsynchro polarity inverted Selects inverted synchronization signal polarity
set extsynchro exposure external Configuration of exposure duration done through
synchronization signal
set extsynchro exposure internal Configuration of exposure duration done internally
set extsynchro source external
Use synchro connector as external synchro source (FW
1.1.0 or above)
set extsynchro source cc1 Use CL CC1 as external synchro source (FW 1.1.1 or
above)
set extsynchro source cc2
Use CL CC2 as external synchro source (FW 1.1.1 or
above)
set extsynchro source cc3 Use CL CC3 as external synchro source (FW 1.1.1 or
above)