FISCHBEINCOMPANY
The Leader in Bag Closing Technology
REF : 14810F-GB
ED.A10/2001
18
7. Tighten the screw to clamp the
needle in place .
The nut is designed so that it
does not require excessive
force to tighten , a firm torque
will be sufficient .
8. Lower the presser foot .
9. Check to see if the needle is
passing through the middle of
the needle guard . (11883)
See also Fig : 5A .
10.Replace the pulley guard .
11.Re - thread the machine .
12.Use always genuine Fischbein
D5 needles .
CAUTION !!!
Keep always your fingers
away from under the
needle .
To Next Page
Loading...
