FISCHBEINCOMPANY
The Leader in Bag Closing Technology
REF : 14810F-GB
ED.A10/2001
27
7. Replace the feed dog (11203) on the feed dog carrier block (11437).
8. Replace the throat plate (11210) .
9. Replace the looper cover
(11102) .
10. Rotate the lifter lever back to
it’s initial position .This will
replace the presser foot on
the throat plate .
11. Cycle the machine until the
feed dog is at the top of it’s
stroke to verify the feed dog
height . This should be
approximately 2,4 mm . The trailing edge of the feed dog should be
0,25 mm higher than the leading edge. This adjustment is made at the
factory and should not need changing , even when replacing the feed
dog .
12. Your bag closer is now ready to use !!!
MOTOR INSTRUCTIONS .
The motors used on Fischbein bag closers are not designed for
long-run periods without stops .
They are produced specially for numerous starts and stops as is
the case for bag closing operations .
Little maintenance will be required but periodic inspection of the
motor brushes will assure that your machine continues to operate
at maximum efficiency . The brushes should be at least 6 mm in
length in order for the motor to run properly .
We recommend that the brush be checked after every 100 hours of use .
To check and replace the brushes if necessary use the following
procedure .
1. Unplug the machine .
2. Unscrew brush holders from the motor and take out the used brushes .
3. Check the length , if they are still useable , replace them and continue
to use the machine .
4. If they are close to being expended , it may be time to order replacements .
5. If you are replacing your brushes , do so now .
6. Replace the brush holder caps .
7. The machine is now ready to use .
To Next Page
Loading...
