421827
10
2.21 Control Panel FabricSmart– (IW)
2.22 Control Panel WashSmart– (GW & WA)
2.23 Control Panel QuickSmart– (MW)
2.24 Important Screw / Bolt Torque Settings
Below are the important screw torque settings for SmartDrive™ washers. These settings must be
adhered to. For all other screws and bolts that are not listed, we recommended that they are
tightened sufficiently without being over-tightened.
Screw / Bolt Torque (Nm)
Pump hood to cap to outer bowl 3Nm
Rotor bolt to shaft 8Nm
Nut Bearing to Shaft 18Nm
Stator to Outer bowl 5Nm
Nut Agitator to Shaft 4Nm
Spline Driven to Inner Bowl Base 1.5Nm
Nozzle Inlet to Top Deck 0.4Nm
Bracket Pump to Outer Bowl 3Nm
To Next Page
Loading...
