421827
28
2. Press the WATER LEVEL UP button so that the Medium water level LED is lit.
3. Press the POWER button to turn the display off (the 3 rightmost wash progress LEDs will be
flashing).
4. Press the POWER button to turn the machine on.
The machine can now be tested on any cycle.
Note: This feature is designed as a service aid only and should be OFF in the customer’s
home. To return to normal operation, and to return the recycle feature to the factory
setting, switch the machine off at the wall or disconnect from the mains supply.
5.1.6 Hot Bowl Flag
If the machine has been filled with hot water and has not had a cold rinse, it will not spin up to its
full speed of 1000 RPM. Its maximum speed will be restricted to a maximum of 700 RPM. This is
to prevent distortion of any internal plastic components that may occur at a high spin speed.
To check to see if this flag has been enacted, firstly enter diagnostic mode (Refer to Section 5.1).
The LED adjacent to Q
UICK WASH on the WashSmart, GW & WA machines and the ECO ON for
the QuickSmart machine will be lit.
To clear this flag and allow the machine to spin to 1000RPM, either press the OPTIONS or ECO
button while in diagnostic mode turning the LED off, or put the machine through a complete final
rinse.
5.1.7 Data Download
Enter diagnostic mode. Press START/PAUSE. The Lid Lock LED will now be on and flickering.
Place the download pen over this LED and follow the instructions supplied with the data download
program.
5.2 FabricSmart, IW (intuitive)
To enter the DIAGNOSTIC mode, ensure the mains is on at the supply point. Press and hold the
Lifestyles/Options
and Select buttons. Keep the buttons pressed for at least 2 seconds,
after which time two beeps will sound and the screen below will appear.
Use either Scroll arrows
or to highlight the screen you wish to view, then touch the Select
button to enter the appropriate screen.
To Next Page
Loading...
