421827
17
Water Level Settings
Tolerance for each water level = +/- 15mm
3.7.2 Auto Water Level (WashSmart, GW, WA Models)
The machine automatically selects the appropriate water level for the load when AUTO Water
Level is selected, and will choose one of the pre-existing 5 water levels (low, medium low, medium,
medium high and high). During fill the machine pauses occasionally to sense the water level. The
machine checks if the water level is correct by using a series of 2 different agitate strokes. A slow
stroke to sense the load and an agitate stroke to mix the load. If the machine detects that the
water level is too low it will fill with more water and check the level again.
When washing an unusual load, e.g. large bulky garments, pillows, it is recommended that the
water level is manually selected.
Manually select the water level if there is already water in the bowl.
If the machine does not fill to the correct level, the auto water level can be adjusted in the Option
Adjustment Mode. Refer to the Use & Care manual for the various options adjustments available.
To enter the option adjustment mode:
1. Plug the machine in but do not press the POWER.
2. Press and hold the Start / Pause button, then press Power
3. Three quick beeps will be heard and the machine will show an unusual pattern of lights.
4. Carry out any option adjustments necessary.
5. Press the POWER button to return to the normal mode.
High GW712 (50mm)
GW612 (50mm)
MW612 (50mm)
GW512 (60mm)
MW512 (60mm)
Medium High GW712 (114mm)
GW612 (110mm)
GW512
115mm
Medium GW712 (177mm)
GW612 (175mm)
MW612 (175mm)
GW512 (180mm)
MW512 (180mm)
Medium Low GW712 (251mm)
GW612 (250mm)
GW512
255mm
Low GW712 (304mm)
GW612 (305mm)
MW612 (305mm)
GW512 (310mm)
MW512 (310mm)
To Next Page
Loading...
