421827
55
8.4 Removal of Display Module FabricSmart IW
(a) Follow instructions for removal of
console. (Refer to Section 8.2).
(b) Disconnect the wiring harness from the
motor control module
(c) Remove the 4 screws securing the display
module to the console
(d) Remove the display module from the
housing by pivoting the display away from
the console
Reassembly:
Refit in the reverse manner
8.5 Removal of Water Valves
(a) Follow the procedure for removal of
Console. (Refer to Section 8.2).
(b)
Disconnect the Display wiring harness from
the Motor Control module & place console
out of the way.
(c) Disconnect wiring harness to each coil by
first pulling downwards on the retaining clip.
(d) Disconnect Thermistor harness from the
Motor Control module.
(e) Remove screw securing the outlet nozzle to
the top deck.
(f) Pull upwards on the spigot to release the
nozzle from the seal in the top deck. As
soon as the seal is broken most of the
residual water will drain from the nozzle.
Remove the water valves from the top deck
ensuring no water comes in contact with
any electrical connections.
Reassembly:
Refit in reverse manner.
8.6 Removal of Recirculating Valve
The Recirculating valve is situated at the bottom
of the outer bowl beside the pump. If the valve
requires service, remove the hose clips (3)
connecting the hoses to the valve, and remove
the screwed clamp around the drain hose to the
valve. The valve now can be removed for
cleaning or checking. This is best achieved by
working from underneath the machine.
Reassembly:
Refit in reverse manner, ensuring that the Valve
orientation is correct with the drain outlet
connected to the drain hose. Flapper will have
the Recirculation outlet in the closed position.
To Next Page
Loading...
