421827
33
5.4 Data Download
To activate the data download, enter the diagnostic mode with the power on at the supply point
press and hold the Lifestyles/Options
and Select buttons. Keep the buttons pressed for at
least 2 seconds, after which time two beeps will sound. Then press the Start/Pause button.
The LED above the Lifestyles button will be on and flickering.
Place the download pen over this LED and follow the instructions supplied with the data download
program.
5.5 Showroom Mode
Showroom mode will play the introduction and repeat it continuously, until the machine has been
isolated from the power supply.
To access the showroom mode follow the steps below.
1. Turn the power supply to the washing machine on.
2. During the introduction sequence on the LCD display (which lasts for approximately 1
minute) press and hold the START/PAUSE button and the SELECT
button, and hold
these buttons for at least two seconds.
To exit, turn off the power supply to the washing machine at the wall.
LED for data download
Press and Hold START/PAUSE , then press the SELECT button
To Next Page
Loading...
