Fisher & Paykel SmartDrive - 8.18 Outer Bowl Removal

421827
60
8.17 Removal of Hanning Pump Hood
(c) Follow the procedure for removal of Inner
Bowl. (Refer to Section 8.14).
(d)
Remove the bolt securing the pump Hood
to the outer bowl.
Reassembly:
Refit in the reverse manner. Ensure that the
gasket is not pinched between the pump hood
and outer bowl.
8.18 Removal of Outer Bowl from the Cabinet
(a) Follow the procedure for removal of the Top
Deck. (Refer to Section.8.11).
(b)
Follow the procedure for removal of Inner
Bowl. (Refer to Section 8.14).
(c)
Thread the drain hose back in to the
cabinet.
(d) Remove the screw securing the drain hose
fixture to the cabinet.
(e) Press tab and rotate fixture carefully so
remaining tabs clear the cabinet.
(f) Remove all four suspension rods, by lifting
upwards on the top suspension bracket.
Start with the suspension rod that attaches
to the drain hose / wiring assembly, and
then do the opposing side.
Note: The pressure tube linkage will need to
be unclipped from the suspension rod first.
(g) With the suspension rods removed from the
cabinet carefully lift the outer bowl
assembly out of the cabinet, taking care not
to cut the drain hose on any sharp edges of
the cabinet.
Reassembly:
Refit in reverse manner.
Press tab and rotate fixture carefully