Fisher & Paykel SmartDrive - Removal of Cord Set; Removal of Lid Lock

421827
57
8.9 Removal of Cord Set
(a) Follow the procedure for removal of water
valves. (Refer to Section 8.5).
(b)
Disconnect the mains plug to the Motor
Control Module.
(c) Slide the strain relief to the left and slide
out.
Reassembly:
Refit in reverse manner.
8.10 Removal of Lid Lock
(a) Follow the procedure for removal of
console. (Refer to Section 8.2).
(b)
Disconnect the Display wiring harness from
the Motor Control module & place console
out of the way.
(c) Disconnect lid lock wiring harness at the
Motor Control Module.
(d) Remove Motor Control Module from the top
deck (Refer to Section 8.8).
(e)
Remove wiring cover from rear right hand
corner of top deck.
(f) Carefully remove the two lid buffers from
the front left & right side of the top deck by
levering upwards, taking care not to
damage the top deck.
(g) Remove the two screws under the buffers
securing the top deck to the cabinet.
(h) Lift the top deck upwards and remove the
screw securing the lid lock to the underside of the top deck. Move the front of the lid lock
downwards and outwards.
(h) Unclip the right hand rear tab of the top deck from the cabinet and raise the corner of the top
deck upwards slightly to allow the wiring harness to be removed.
Reassembly:
Refit in the reverse manner.
Slide