Fisher & Paykel SmartDrive - 5.6 User Warnings

421827
34
5.5.1 Settings Adjustment Mode
To access the settings menu
 Touch the Lifestyles/Options button, OPTIONS will be highlighted, Scroll with the arrows
or highlighting SETTINGS and select . The SETTINGS menu will then be displayed.
 Scroll and select the option you wish to adjust.
 Scroll and highlight your preferred setting and then touch the select
button. This option will
be permanently set.
To unset the option, repeat the above steps.
 To exit and save the SETTINGS, touch the back
button.
The options that can be adjusted are:
 Wash Temperature. Each increment is approximately 2
°
C.
 Auto Water Level. This increases or decreases the fill level that auto will detect.
 Default Rinse. The default rinse can be set to either; spray and deep, single deep, double deep
or shower.
 Easy Iron Spin Speed. The spin speed for the Easy Iron cycle can be set at either slow
(330rpm) or medium (670rpm).
 Out of Balance Recovery. The out of balance recovery action can be set to be either automatic,
where the machine will fill with water and agitate to redistribute the load, or it can be turned off,
where the machine will stop and beep.
 End of Cycle Beeps. These can be set to zero, five or fifteen.
 Reset Defaults. Will cancel any of the adjustments made and reset all settings to the factory
defaults.
 Display. Enables the adjustment of the brightness & contrast of the LCD display.
5.6 User Warnings QuickSmart WashSmart MW, GW & WA
There are a number of warnings, which are generally caused by the user or poor installation.
These warnings should be able to be corrected by the user. The machine signals user warnings
by flashing LEDs and a rippling set of 5 beeps repeated every 6 seconds. This is the same tone
that is heard when the machine is first plugged into the mains power.
Most of this information is available to the user in the Use and Care manual.
5.6.1 Hot Water Temperature LED Flashing (Insufficient Hot Water)
Possible causes:
1. Check that the hot water is connected and that the tap is turned on.
2. Check that the water temperature is not too low. The water temperature may need to be 60
o
C
for a hot wash.
3. Check that the hot water inlet hose is not connected to the cold water supply.
4. Check that there are no kinks in the inlet hoses.
5. Check that the filter on the hot inlet hose at the tap end is not blocked.
6. Check that the filter screen in the hot inlet valve is not blocked.
7. Check the resistance of the thermistor. Resistance is 10kΩ @ 25
o
C. Replace if well outside
of this range.
8. Check the size is set correctly.
Note: If the machine is set to controlled cold, hot water may be required to achieve 20
o
C.