421827
54
8 SERVICE PROCEDURES
In order to service and to gain access to components within the machine, certain procedures must
be followed. These procedures are set out below.
Servicing note
(a) To avoid stripping screws, do not over tighten when re-assembling parts. If using a power
screwdriver, have the torque setting on low.
(b) Take care not to damage wire terminals on removal as some of these have release clips.
(c) On completion of any service carried out to the washing machine, all safety tests as required
by law must be carried out.
8.1 Removal of Lid
(a) Open the lid fully and then lift off vertically.
Reassembly
Refit in reverse manner, ensuring that the hinge
lugs on the lid are vertical.
8.2 Components in Console Area
(a) Remove the lid. (Refer to Section 8.1).
(b) Remove the two screws at the rear of the console securing the console to the top deck.
(c) Tilt the console forward.
Reassembly:
Refit in reverse manner.
8.3 Removal of Display Module QuickSmart, WashSmart,
MW, GW & WA
(a) Follow instructions for removal of console.
(Refer to Section 8.2).
(b)
Disconnect the display wiring harness from
the Motor Control Module.
(c) Unclip the 6 tabs to release the circuit
board.
(d) Lift the display module clear of the console.
Reassembly:
Refit in reverse manner.
Lift
Tabs
To Next Page
Loading...
