421827
41
5.10 Binary Decoding Chart – 8 Bits (0-255) QuickSmart,
WashSmart, MW, GW & WA
short
wash
rinse spin
1248163264128
000 001 010 011 100 101 110
111
00000
0 1 2 3 4 5 6 7
00001
8 9 10 11 12 13 14 15
00010
16 17 18 19 20 21 22 23
00011
24 25 26 27 28 29 30 31
00100
32 33 34 35 36 37 38 39
00101
40 41 42 43 44 45 46 47
00110
48 49 50 51 52 53 54 55
00111
56 57 58 59 60 61 62 63
01000
64 65 66 67 68 69 70 71
01001
72 73 74 75 76 77 78 79
01010
80 81 82 83 84 85 86 87
01011
88 89 90 91 92 93 94 95
01100
96 97 98 99 100 101 102 103
01101
104 105 106 107 108 109 110 111
01110
112 113 114 115 116 117 118 119
01111
120 121 122 123 124 125 126 127
10000
128 129 130 131 132 133 134 135
10001
136 137 138 139 140 141 142 143
10010
144 145 146 147 148 149 150 151
10011
152 153 154 155 156 157 158 159
10100
160 161 162 163 164 165 166 167
10101
168 169 170 171 172 173 174 175
10110
176 177 178 179 180 181 182 183
10111
184 185 186 187 188 189 190 191
11000
192 193 194 195 196 197 198 199
11001
200 201 202 203 204 205 206 207
11010
208 209 210 211 212 213 214 215
11011
216 217 218 219 220 221 222 223
11100
224 225 226 227 228 229 230 231
11101
232 233 234 235 236 237 238 239
11110
240 241 242 243 244 245 246 247
11111
248 249 250 251 252 253 254 255
The above table shows the 8 wash progress LEDs with the SPIN LED corresponding to the LED
on the far right hand side.
8 bit binary calculations: Least Significant Byte (LSB) is the SPIN LED. If it is on this has a value
of 1. The Most Significant Byte (MSB) is the first wash LED, this has a value of 128 if it is on. The
intermediate LEDs have values of 64, 32, 16, 8,4 and 2.
By adding up the value of all the LEDs that are illuminated the 8 bit binary value may be calculated.
Note: If the Spin LED is optically downloading it will be ‘flickering’, this does not
necessarily count as part of the 8 bit value.
To calculate a 16 bit value (eg. cycle count) TOTAL = (high byte x256) + (low byte).
8 WASH PROGRESS LEDs
To Next Page
Loading...
