Fisher & Paykel SmartDrive - 5.7 Diagnostic Table

421827
37
5.7 Diagnostic Table QuickSmart, WashSmart, MW, GW &
WA Models
To use this table, firstly enter Diagnostic Mode (Refer to Section 5.1). The different levels of
information can be extracted by using the Spin Speed up and down buttons.
Diagnostic
Level
Spin Speed LEDs
Fast Med Slow Hold
Diagnostic Info Displayed
0 OFF OFF OFF OFF Last User Warning Number
1 OFF OFF OFF ON Last User Warning Cycle Position
2 OFF OFF ON OFF
Factory use only – Not applicable to the field
3 OFF OFF ON ON Fault Code at last fault (if within the last 8 cycles)
4 OFF ON OFF OFF
Factory use only – Not applicable to the field
5 OFF ON OFF ON Cycle count at last fault (low byte)
6 OFF ON ON OFF Cycle count at last fault (high byte)
7 OFF ON ON ON Cycle position at last fault
8 ON OFF OFF OFF Water Temp (deg C)
9 ON OFF OFF ON Cycle count (low byte)
10 ON OFF ON OFF Cycle count (high byte)
11 ON OFF ON ON Motor speed (RPM)
12 ON ON OFF OFF Water Level
13 ON ON OFF ON EEPROM version number
14 ON ON ON OFF Motor Controller software Version No.
15 ON ON ON ON Display Software Version No.
Diagnostic Mode 0, Last User Warning Number
The Last User Warning Number is displayed on the Wash Cycle LEDs in binary* form and can be
calculated by totalling the binary* value of the Wash Cycle LEDs. Using the chart below to identify
the last user warning.
Binary Count User Warning
0 No warning
1 No taps
2 Overload
3 OOB
4 Suds
5 No Hot
6 No Cold
7 Agitate overloaded
8 Lid not Locked
Diagnostic Mode 1: Wash Cycle Position of Last User Warning Number
The Wash Cycle position of the last user warning is primarily displayed via the Wash progress
LEDs. The 8 Wash progress LEDs correspond to the 8 stages of a Wash Cycle. Initially, all 8 Wash
Cycle LEDs are illuminated and turn off from left to right as each wash stage is completed ie if the
user warning was suds (in diagnostic mode 0) and the 1
st
Rinse LED was lit in this level, this was
the stage in the cycle where the user warning occurred.
Diagnostic Mode 3: Fault Code of Last Fault (if within the last 8 Wash Cycles)
Also, sometimes referred to as the detailed fault code. The fault data is displayed via the Wash
progress LEDs in binary* form (Refer to Section 5), this will relate to a fault code (fault codes are
contained in
section 7 of this manual). If there are no LEDs lit, a fault code hasn’t occurred in the
last 8 cy
cles.