421827
36
5.6.7 Lid Lock LED Flashing
This warning is generated if the electronics have detected that the lid has not been closed.
1. Check that the tang on the lid is not bent or broken.
2. If the lid is closed and the tang is ok, replace the lid-lock assembly.
5.6.8 Demonstration Mode (All LEDs flashing in patterns)
This feature is designed for in store demonstration purposes. So the machine can draw attention
to itself with a selection of flashing LEDs. In this mode it cannot be started. To select
demonstration mode press and hold the Advance button, then press the Power button.
During demonstration mode the LEDs will alternate between all on, LEDs flashing, and all LEDs
off. To return to normal operation, the mains supply must be switched off.
To Next Page
Loading...
