Fisher & Paykel SmartDrive - Removal of Top Deck; Removal of Neck Ring; Removal of Agitator

421827
58
8.11 Removal of Top Deck
(a) Follow the procedure for removal of
console. (Refer to Section 8.2).
(b)
Disconnect the Display wiring harness
from the Motor Control module & place
console out of the way.
(c) Follow the procedure for removal of water
valves. (Refer to Section 8.5).
(d)
Follow the procedure for removal of Motor
Control Module. (Refer to Section 8.8).
(e)
Follow the procedure for removal of cord
set. (Refer to Section 8.9).
(f)
Remove wiring cover from rear right
hand corner of top deck.
(g) Carefully remove the two lid buffers from
the front left & right side of the top deck by
levering upwards, taking care not to
damage the top deck.
(h) Remove the two screws under the buffers
securing the top deck to the cabinet.
(i) Lift the front edge of the top deck upwards
and release the two rear tabs.
(j) Lift the top deck clear.
Reassembly:
Refit in reverse manner.
Note: The inlet nozzle can be removed when the top deck is lifted.
8.12 Removal of Neck Ring
(a) Follow the procedure for removal of lid.
(Refer to Section 8.1).
(b)
Carefully remove the two lid buffers from
the front left & right side of the top deck by
levering upwards, taking care not to
damage the top deck.
(c) Remove the two screws under the buffers
securing the top deck to the cabinet.
(d) Lift the front edge of the top deck upwards
and tilt backwards.
(e) Release the bias spring from the front left
suspension rod.
(f) Unclip the neck ring from the outer bowl
and remove.
Reassembly
Refit in reverse manner
8.13 Removal of Agitator
(a) Lift lid.
(b) Remove fabric softener dispenser.
(c) Release the agitator bolt by turning ant-clockwise.
(d) Lift agitator out and clear.
Reassembly:
Refit in the reverse manner.