421827
14
Note:
If the required temperature still can’t be obtained, advance the wash progress LED (as
described in the procedure above) across to the spin LED and manually adjust the flow of
the taps.
3.4.2 Wash Temperature Adjustment (WashSmart, WA Only)
1. Turn the machine on at the wall but of at the console.
2. Press and hold down the START/PAUSE button, then press the POWER. Two quick beeps
will be heard and the machine will show an unusual pattern of lights. In this mode the lights are
used to indicate the different options available.
3. Use the Wash Temp buttons to select the WASH TEMPERATURE to be adjusted.
4. The wash progress lights show the temperature adjustment possible for that temperature.
Pressing the ADVANCE will cause the wash progress light that is on to change. Advancing the
Wash Progress light will increase the wash temperature. If the ADVANCE button is kept
pressed, the light will scroll back to the coldest setting available for that wash temperature
3.4.3 Controlled Cold (WashSmart, WA Only)
If the cold water inlet temperature is very low (below 20
o
C), an effective wash will not be obtained.
The controlled cold option solves this problem by adding a small amount of hot water to raise the
temperature of the wash. We have called this ‘Controlled Cold’.
1. Turn machine on at the wall but do not press POWER.
2. Press and hold down the START/PAUSE button, then press POWER. Two quick beeps will be
heard and the machine will show an unusual pattern of lights. In this mode the lights are used
to indicate the different options available.
3. Use the Wash Temp buttons to select the COLD wash temperature.
4. The Wash Progress lights show the temperature adjustment possible. When the first progress
light is on, the machine will fill with cold tap water only. Press ADVANCE to select the second
light and the SmartDrive
will control the temperature to approximately 20°C. Each following
light equals approximately a 1°C temperature rise.
To Next Page
Loading...
