Instruction Manual
D103409X012
Introduction
May 2013
3
Section 1 Introduction
Scope of Manual
This instruction manual is a supplement to the DVC6200 Series Quick Start Guide (D103556X012) that ships with
every instrument. This instruction manual includes product specifications, installation information, reference
materials, custom setup information, maintenance procedures, and replacement part details for the FIELDVUE
DVC6200 digital valve controller, device revision 2, firmware revision 9, 10, and 11, instrument level AC, HC, AD, PD,
and ODV.
Note
Firmware 9, 10, or 11 is required for the DVC6200 digital valve controller. A printed wiring board with earlier versions of firmware
must be updated before using with the DVC6200.
Note
All references to the DVC6200 digital valve controller include the DVC6205 base unit unless otherwise indicated.
This instruction manual describes using the 475 Field Communicator with device description revisions 1 and 2 to setup
and calibrate the instrument. You can also use Fisher ValveLink software version 10.2 or higher to setup, calibrate, and
diagnose the valve and instrument. For information on using ValveLink software with the instrument refer to ValveLink
software help or documentation.
Do not install, operate, or maintain a DVC6200 digital valve controller without being fully trained and qualified in
valve, actuator, and accessory installation, operation, and maintenance. To avoid personal injury or property damage,
it is important to carefully read, understand, and follow all of the contents of this manual, including all safety cautions
and warnings. If you have any questions about these instructions, contact your Emerson Process Management sales
office before proceeding.
Conventions Used in this Manual
Navigation paths and fast‐key sequences are included for procedures and parameters that can be accessed using the
Field Communicator.
For example, to access Setup Wizard:
Field Communicator Configure > Guided Setup > Setup Wizard (1‐1‐1)
Refer to Appendix B for Field Communicator menu trees.
Note
Field Communicator menu sequences used in this manual are for instrument level HC, AD, PD, and ODV. Refer to the AC menu tree
in Appendix B for AC menu sequences.
To Next Page
Loading...
Need help?
General
