Lit. No. 44224, Rev. 14 102 August 15, 2011
14. Turn the control ON and raise and lower the
snowplow several times. Activate the control
FLOAT function and manually collapse the
lift ram all the way after each lowering of the
blade. With all rams fully retracted, turn the
control OFF.
15. Fill the reservoir to the top of the fi ll hole and
replace the fi ll plug.
MAINTENANCE
WARNING
To prevent accidental movement of
the blade, always turn the control OFF
whenever the snowplow is not in use. The
power indicator light will turn OFF.
Air Removal – XLS™ Blades
11. Turn the control ON and completely extend
and retract the driver-side wing several times.
Repeat for the passenger-side wing. With
the wing and lift rams fully retracted, turn the
control OFF.
12. Fill the reservoir to the top of the fi ll hole and
replace the fi ll plug.
NOTE: Loosen fi ll plug slowly to relieve any
pressure in the reservoir.
To Next Page
Loading...