Fisher Minute Mount 2 system - HT Series Joystick Control

Lit. No. 44224, Rev. 14 44 August 15, 2011
HT Series™ JOYSTICK CONTROL
1. Turn the vehicle ignition switch to the "ON" or
"ACCESSORY" position.
2. Move the ON/OFF switch on the side of
the control to the "ON" position. The power
indicator light glows red, indicating the control
is ON. The indicator light glows red whenever
the control and the vehicle ignition switch are
both ON and the electrical connections to the
snowplow are completed.
The ON/OFF switch operates as an
emergency stop if required.
WARNING
To prevent accidental movement of the
blade, always move the ON/OFF switch to
OFF whenever the snowplow is not in use.
The power indicator light will turn OFF.
OPERATING YOUR SNOWPLOW
L
R
RAISE
LOWER
ON/OFF FLOAT
12
34
Power Indicator
Light (red)
FLOAT Light
(green)
ON/OFF Switch
(Emergency Stop)