Lit. No. 44224, Rev. 14 103 August 15, 2011
13. Turn the control ON. Angle the blade fully left
and right and raise and lower the snowplow
several times. Activate the control FLOAT
function and manually collapse the lift ram all
the way after each lowering of the blade. With
all rams fully retracted, turn the control OFF.
14. Fill the reservoir to the top of the fi ll hole and
replace the fi ll plug.
MAINTENANCE
WARNING
To prevent accidental movement of
the blade, always turn the control OFF
whenever the snowplow is not in use. The
power indicator light will turn OFF.
Hose or Fitting Replacement
DO NOT use thread sealant/tape on hoses or
fi ttings. This could damage the product. Follow
recommended replacement procedures for fi ttings
and hoses.
1. Lower the snowplow completely and turn the
control OFF.
NOTE: Loosen fi ll plug slowly to relieve any
pressure in the reservoir.
WARNING
Lower blade when vehicle is parked. Keep
8' clear of blade drop zone. Temperature
changes could change hydraulic pressure,
causing the blade to drop unexpectedly or
damaging hydraulic components. Failure
to do this could result in serious personal
injury.
To Next Page
Loading...