Lit. No. 44224, Rev. 14 88 August 15, 2011
PRESEASON CHECK
Before the snow season, check your equipment to
make sure it's in working condition. Here are some
tips for getting your equipment ready:
• Clean and tighten all electrical connections
and coat with dielectric grease to prevent
corrosion.
• Check hydraulic system for leaks and cracked
or damaged hoses.
MAINTENANCE
WARNING
Lower blade when vehicle is parked. Keep
8' clear of blade drop zone. Temperature
changes could change hydraulic pressure,
causing the blade to drop unexpectedly or
damaging hydraulic components. Failure
to do this could result in serious personal
injury.
• Drain hydraulic system and refi ll with
recommended hydraulic fl uid. For hydraulic
fl uid type and fi lling instructions, see Hydraulic
System, Annual Fluid Change, in this section
of the manual.
• Replace worn or damaged parts.
• Check all mounting points and tighten
fasteners, on both snowplow and vehicle.
Verify all cotter pins are in place.
• Repaint blade assembly and attachments, as
necessary, to protect the metal.
• Install auxiliary and fl ashing lights for
compliance and visibility in accordance with
local regulations.
• Check headlamps, auxiliary lights, heater and
windshield wipers for proper operation.
To Next Page
Loading...