Fisher Minute Mount 2 system

To Next Page

To Previous Page

Lit. No. 44224, Rev. 14 71 August 15, 2011

OPERATING YOUR SNOWPLOW

Fluid Level

With Minute Mount

2 system attached to the

vehicle, activate the control. For straight blades,

any angle will do, but for XtremeV™ and XLS

blades, move blade wings to fully retracted (vee)

position. Then, for all blades, activate the control

FLOAT function and manually collapse the lift ram

all the way. Turn the control OFF. Remove the ﬁ ll

plug.

HT Series™ Blades: Fill the reservoir to within

2-1/2" from the top of the ﬁ ll hole and replace the

ﬁ ll plug.

XtremeV, XLS and other Straight Blades: Fill

the reservoir to the top of the ﬁ ll hole and replace

the ﬁ ll plug.

For hydraulic ﬂ uid type and ﬁ lling instructions, see

Hydraulic System, Annual Fluid Change, in the

Maintenance section of this manual.

XLS™ Blades

Breather

Quill

Reservoi

Valve

Manifold

Motor

Drain

Cap

Fill

Plug

Motor

Relay

set limits, the relief valve opens allowing ﬂ uid to

escape and the ram retracts.

Fisher Minute Mount 2 system - Fluid Level