Fisher Minute Mount 2 system - Page 34

Lit. No. 44224, Rev. 14 35 August 15, 2011
ATTACHING SNOWPLOW TO VEHICLE
4. Push headgear toward vehicle to
allow connecting pins to fully engage
pushplates. If unable to push headgear
from in front of blade, stand in front
of headgear on driver side and push
headlamp bracket.
HT Series™ Blades: Using headgear push
bar, push headgear toward vehicle to allow
connecting pins to fully engage pushplates.
5. Pull out jack lock. Push pin release handle
into stop.
HT Series Blades: Push up on jack
retract lever. Jack will raise automatically.
Pull jack lock out, rotate jack into up
position and engage jack lock. Stop here,
attaching is complete.
6. While holding jack lock out, use jack
handle to raise jack fully. Release jack lock.
7. Attach all electrical connectors.
P
U
S
H
Attachment
Arm
Jack
Lock
Headgear
Jack
(fully raised)
Headlamp
Bracket
Jack
(lowered)
Pin Release
Handle
(lowered)
Jack
Handle
Connecting
Pin
Pushplate
Jack
Stop
Pin Release
Handle (raised)