Lit. No. 44224, Rev. 14 50 August 15, 2011
OPERATING YOUR SNOWPLOW
Function Description of Operation
L
(Angle
Left)
With wings in a straight line, press the L
button to move both wings to the angle
left position to cast snow to the driver's
left side. The left wing retracts while
the right wing extends (XtremeV™).
Function times out after 3.0 (XtremeV) or
3.25 seconds (XLS™).
R
(Angle
Right)
With wings in a straight line, press the
R button to move both wings to the
angle right position to cast snow to the
driver's right side. The right wing retracts
while the left wing extends (XtremeV).
Function times out after 3.0 (XtremeV) or
3.25 seconds (XLS).
NOTE: If control function times out before
desired blade movement is complete, release
button and press again.
Scoop/Retract (Vee) Blade Position
The two round buttons located to the left and right
of the RAISE button move both wings at the same
time into the blade positions described in the
following table.
Function Description of Operation
SCOOP
Press this button to extend both
wings forward into the scoop position.
Function times out after 5.0 (XtremeV) or
5.5 seconds (XLS).
RETRACT
(VEE)
Press this button to draw both wings
into the fully retracted (vee) position.
Function times out after 3.0 (XtremeV) or
4.5 seconds (XLS).
RAISE
ON/OFFFLOAT
12
S
C
O
O
P
R
E
T
R
A
C
T
To Next Page
Loading...