© FJDynamics. All rights reserved.1
FJDynamics AT2 Auto Steer System Hardware Installation Manual
1 Product Introduction
2 Preparation Before Installation
FJDynamics AT2 Auto Steer System is an autosteering system that is launched by
FJDynamics for agricultural machinery and supports assisted straight line driving. The
system consists of the control terminal, GNSS receiver, electric steering wheel, and wiring
harnesses. The control terminal runs the software developed by FJDynamics.
Before installation, read the safety advice in this manual carefully to avoid doing harm to
people and equipment.
Note that the following safety advice cannot cover all possible dangerous situations.
•
Do not install and commission the equipment in environments with high temperature,
heavy dust, harmful gases, ammables, explosives, electromagnetic interference (for
example, around large radar stations, transmitting stations, and substations), unstable
voltages, great vibration, and strong noise.
•
Do not install the equipment in places where water is likely to accumulate, seep, drip,
and condense; otherwise, the equipment ports could be damaged.
2.1 Safety Instructions
2.1.1 Installation
To Next Page
Loading...
