FJDynamics FJD 3D - Requirements for Installation Site

Hardware Installation Manual for FJD 3D Excavator Guidance System
4
Copyright © FJ Dynamics Technology Co., Ltd. All Rights Reserved.
2. Don’t install the equipment in places where water accumulation, water seepage, dripping, and
moisture condensation most likely happen.
3. Install or remove the equipment as described in the hardware installation manual.
Removal Safety
1. Once installed, don’t frequently remove the equipment to avoid damages.
2. Turn off all power supplies and disconnect all power lines and cables before removal.
Electrical Safety
1. The local laws and regulations must be observed during electrical operations. The relevant
personnel must be qualified.
2. Please carefully check for potential hazards in the work area, for example, wet ground.
3. Before installation, be familiar with the location of the emergency power switch and turn off the
power switch first in the event of an accident.
4. Check carefully when it is necessary to turn off the power.
5. Do not put the equipment in a humid place, and no liquid is allowed to enter the equipment.
6. Keep away from wireless transmitting stations, radar transmitting stations, high-frequency and
high-current equipment, microwave ovens, and other high-power wireless equipment.
7. Direct or indirect contact with high voltage or mains power through wet objects may cause fatal
danger.
8. Irregular and incorrect electrical operations may cause accidents such as fire or electric shock, and
even cause serious and fatal harm to the human body and equipment.
2.2 Requirements for Installation Site
To ensure the normal operation of the equipment and prolong its service life, the installation site is
required to meet the following standards.
Installation Location Requirements
1. Install the equipment in an open environment, and ensure that the closed environment where the
equipment is installed has a good ventilation and cooling system.
2.Ensure that the equipment is installed at a position firm enough to support the weight of control
terminal and accessories.
3. Ensure that the installation location is suitable for the size of control terminal, with some space left