Manual Flamcomat MK-U G4
We reserve the right to change designs and technical specifications of our products.
8
ENG
4.7 Transportation, storage, unpacking
The equipment is delivered in packaging units in accordance with the contract specifications or the specifications
required for certain modes of transport and climate zones. These units meet at least the requirements set out in
the Flamco B.V. packaging directives. In accordance with these directives, expansion vessels must be transported
horizontally and pump units upright; each packaged on throw-away pallets. If the packaging is suitable for use with
hoisting gear, this will be indicated at the designated hoisting points.
Important note: Transport the packed goods as close as possible to the envisaged set-up location and make sure
there is a horizontal, solid surface on which the goods can stand.
Note: Take all necessary precautions to ensure that the expansion vessel cannot topple over or wobble once it has
been unpacked and removed from the pallet.
Suitable li ing lugs are provided for li ing and moving suspended empty vessels prior to installation. Such
devices (li ing lugs) must be used in tandem; avoid side-pulling. Once it has been removed from the pallet and the
packaging, the unit must be transferred by pulling it over suitable surfaces. Use methods that prevent uncontrolled falling,
sliding or tipping over. The li ing lugs on the vessel are designed to li vertically. They may not be subjected to any lateral
force.
The goods may also be warehoused in their packaging. Once it has been removed from its packaging, the equipment must
be put in position, observing standard safety procedures. Do not stack the equipment.
Use only permitted li ing gear and safe tools and wear the required personal protective equipment.
4.8 Operations room
Definition: room which meets the applicable European regulations, European and harmonised standards and relevant
technical rules and guidelines of the professional associations for this field of application. For the use of the expansion
automat as prescribed in this manual these rooms generally contain equipment for
thermal generation and distribution, water heating/cooling and top-up, power source and distribution, such as measuring,
control engineering, control technology and IT.
Access for unqualified and untrained persons must be restricted or forbidden.
The set-up location of the expansion automat must ensure that operation, service, maintenance, inspection, repair,
installation and dismantling can be carried out unhindered and without danger. The floor of the set-up location for the
expansion automat must be such that stability is guaranteed and maintained. Bear in mind that the maximum possible
forces can be exerted from the net mass including the water volume. If stability cannot be guaranteed, there is a danger that
the vessel will tip over or move and, as a consequence in addition to functional defects may lead to personal injury.
The ambient atmosphere must be free from conductive gases, high concentrations of dust and aggressive vapours. There is
the risk of explosion if any combustible gases are present.
Flooded equipment must not be operated. If electrical equipment short circuits, persons or other beings in the water will be
electrocuted. Furthermore, there is a danger of malfunction and partial or irreparable damage to individual components due
to water saturation and corrosion.
4.9 Noise reduction
Installations should be constructed with noise-reduction measures in mind. Mechanical vibrations of the assembly (Module
framework, pipework) in particular can be dampened by using insulation between contact surfaces.
1000 Ltr
To Next Page
Loading...