5. Plug the power cable into the input on
the back and turn on the power switch,
the touch screen is turned on.
6. Click [Tools]-[Setting] in turn to enter page like this, turn to page two, click [Move].
Click the upper arrow in the moving page to make the extruder raises for removing
the paper box on the bottom easier.
Power Switch
Status Language
Calibration Homing
Move Camera
Filament Check
1/3 2/3
Led
x
z
Y
X: 20.00 Y: 45.00 Z: 36.00
7. Open the front door, take out the paper box
inside the printer, the printer unpacking
completed.
09
To Next Page
Loading...
