FLASHFORGE 3D PRINTER Adventurer 3 Pro 2 - The Guide of Using Camera

2.5 The Guide of Using Camera
1. Tap [Tools] - [Settings] on the second page - [Camera], the user can click the [Camera]
button to open it.
2. After the camera is turned on successfully, the icon of camera will appear in Status Bar.
The use of Adventurer 3 Pro 2's camera is introduced as follows.
Camera User Manual
Build
Tools
Filament
Network Preheat
Setting About
Build
Tools
Filament
Move Camera
Filament Check Led
2/4
38