Work Environment Safety
Place Requirements
Filament Requirements
Filament Storage
Legal Notice
Temperature: RT 15-30 ℃; Moisture: 20%-70%
The device must be placed in a dry and ventilated environment.
The distances of the left, right and back side space should be at least 20cm, and
the distance of the front side space should be at least 35cm. Device storage
temperature: RT 0-40 ℃
Do not abuse the filament. Please make sure you use the Flashforge filament or the
filament from the brands accepted by Flashforge.
Nozzle Clogging and damage may be caused by non-Flashforge filament due to
inappropriate material properties.
All the information in this document is subject to any amendment or change without
the official authorization from Flashforge.
Flashforge makes no warranty of any kind with regard to this document, including,
but not limited to, the implied warranties of merchantability and fitness for a particular
purpose.
FCC Notice
This device complies with part 15 of the FCC rules. Operation is subject to the following
two conditions: [1] This device may not cause harmful interference, and [2] this device
must accept any interference received, including interference that may cause undesired
operation.
Flashforge shall not be liable for errors contained herein for incidental consequential
damages in connection with furnishing, performance or use of this material.
This document contains proprietary information protected by copyright.
Copyright 2023 Zhejiang Flashforge 3D Technology Co., Ltd. All rights reserved.
All polymers degrade with time. Do not unpack filament until necessary. Filament
should be stored at clean and dry conditions.
03
To Next Page
Loading...
