The surface on which the Adventurer 3 Pro 2 builds an object
Build Tape
Build Plate
The black tape that covers Adventurer 3 Pro 2’s build plate so
that object can stick to the build plate well
Build Volume
The three dimensional amount of space that an object
will use once it is completed. The largest build volume
is 150*150*150mm.
Extruder
Nozzle
Cooling Fan
Filament Cartridge
Filament Guide Tube
Filament Intake
Solid Glue Stick
This integral extruder device installed on X-Axis. Extruder
draws the filament from the spool, melts it and pushes it
though a nozzle into the build plate.
Also called ‘print head’, which located at the bottom
of the extruder where heated filament is squeezed out.
A specific box for placing Flashforge filament, which is
located on the right of printer.
A white plastic tube that guides the filament from the
filament box to the filament intake
A solid adhesive used for making the model stick to the
build plate firmly
To cool the outer assembly of the extruder and gear motor
An opening located an the top of the extruder
Terms
05
To Next Page
Loading...
