3. Software Introduction & Installation
17
Flash Maker Instructions
1. Download Flash Maker by scanning
the QR code (see below) or from the
app store, register your Flashforge
account, and log in.
2. Click [ ] - [ ], and then turn
on the Wi-Fi switch to connect to
the network.
3. Click [ ] to enter the information
interface, and then click [My Account] to
access the printer's QR code.
4. Use Flash Maker to scan the QR code on
the printer screen to bind the printer to
your account.
QR Code
1. By default, the device name is set to "Adventurer 5M", and its location is set to "Group A"
upon factory settings. You can modify the name and location on the printer's information
interface as needed.
2. Real-time monitoring is only accessible when a camera is installed and the feature is
enabled.
3. The APP does not support connection in the LAN Only mode.
NOTE:
To Next Page
Loading...
