Flashforge Creator 3 Pro - English; Default Chapter; Table of Contents




1.1 - Creator 3 Pro Introduction
1.2 - Packing List
1.3 - Precautions for Unpacking the Equipment

2.1 - Filament Loading
2.2 - Leveling and Calibration
2.3 - Internet Connection


4.1 - File Transfer: Wi-Fi transfer
4.2 - Printing via USB Disk
4.3 - Printing via FlashCloud
4.4 - Model Removal

5.1 - Dual-extruder Printing Mode Setting
5.2 - Mirror/Duplicate Mode
5.3 - Filament Configuration
5.4 - Filament Setting
5.5 - Removal Method of Water-soluble Support Filament
5.6 - Camera Connection

6.1 - Printing Screen
6.2 - Tools Screen
6.3 - Setting Screen

7.1 - Copy the Log
7.2 - Maintenance and Service
7.3 - Unclog the Nozzle
7.4 - Replace the Nozzle Assembly
7.5 - Anti-oozing Plate
7.6 - Daily Maintenance and Use Suggestion

05
06
06
07
08
09
09
12
13
14
14
14
15
15
15
16
16
17
19
19
20
21
22
22
24
25
26
26
26
27
27
28
28
29
04