Finder2.0 User Guide |
www.flashforge.com
The surface on which the Finder2.0 builds an object.
The blue tape that covers Finder2.0’s build plate so that
the object can stick to the build plate well.
The three dimensional amount of space that an object
will use once it is completed. The largest build volume
of Finder2.0 is 140*140*140mm.
Knobs under the build platform that are used for
adjusting the distance between the nozzle and build
plate.
The device that draws the filament from the spool,
melts it and pushes it through a nozzle into the build
plate.
Also called “print head”, which located at the bottom
of the extruder where heated filament is squeezed out.
To cool the outer assembly of the extruder and gear
motor
An opening located at the top of the extruder .
A black plastic piece that guides the filament from the
filament box to the filament intake
A specific box for placing Flashforge filament
A solid adhesive used for making the model stick to the
build plate firmly
A tool that used for cleaning the extruder
After device is turned on, by tapping the black button
once, the printer will be in black screen status(printing
not affected), then if you want to resume to normal
status, tap the black button again.
To Next Page
Loading...
