Flashforge Finder 2.0 - Chapter 4: Hardware Assembly; Filament Installation

Finder2.0 User Guide |
www.flashforge.com
0086-0579-82273989
25
Chapter 4: Hardware Assembly
Your Finder2.0 has been installed before leaving factory, you can start up the Finder2.0
for printing after mounting the filament spool and completing leveling.
4.1 Filament Installation
4-1
(4-1) The filament cartridge is at the rear of Finder2.0. Lift the cartridge out of the Finder2.0.
(4-2) Take out the filament and install the filament. (Note: The filament should feeds from the
bottom of the spool towards the top )
After installing the filament, put the cartridge back to the printer.