Finder2.0 User Guide |
www.flashforge.com
(3-3) Remove the top insert.
3-4
(3-4) You will see Quick Start Guide, Service Information Card, mains lead, filament guide tube
and a tool bag( USB stick*1, Allen wrenches*2, unclog tool*1, screwdriver*1, and scraper*1 )
3-5
（3-5）Discard the blue tape that holds the flat cable in place. Be careful with the flat cable.
3-6
(3-6) Cut off four ribbons that used for fixing the guide rod. Then slide the extruder to make sure
the extruder and the rod are in good condition.
To Next Page
Loading...
