Finder2.0 User Guide |
www.flashforge.com
6-14
(6-14) Click[Edit], then you can add or remove a height.
①New Project
Click [File]--[New Project] can build a blank project. If there is an unsaved
modification on previous project, then it will inform you whether the modification
needs to be saved or not. Click [Yes] will save the modification, click [No] will
abandon it. If click [Cancel] or close tool tip, then will cancel the new project.
6-15
②
Saving
After finishing the model edit and adjustment, there are two ways below to save all
models in the scene.
Method 1:
Click [File]--[Save Project] in the menu bar to save the file as a project file with the
“.fpp”suffix, all models in the scene (include support) are independent . After
reloading the files, extruder configuration information and model position will be the
same as the configuration during saving.
To Next Page
Loading...
