Flashforge Finder 2.0 - Page 54

Finder2.0 User Guide |
www.flashforge.com
0086-0579-82273989
53
②Disconnect Finder2.0
Click [Print]--[Disconnect] to disconnect your PC and Finder2.0.
6.2.14 Tool Menus
①
Control Panel
After connecting PC with Finder2.0, click [Tools]--[Control Panel] to open the
control panel.
● Jog Controls
6-23
a. Jog Mode ： Select the distance that extruder/ build plate move a single time (that is,
the distance extruder/ build plate move upon your single click).
b. Six blue arrow direction button: Control the move along X/Y/Z axis. X/Y axis
button control extruder move, Z axis button control build plate move. Click X-,
extruder will move leftward a specified distance; Click X+, extruder will move a
specified distance rightward. Click Y-, extruder will move forward a specified distance;
Click Y-, extruder will move backward a specified distance. Click Z-, build plate will
move upward a specified distance; Click Z-, build plate will move downward a
specified distance. (Specified distance refers to the move distance you set in Jog Mode.