Finder2.0 User Guide |
www.flashforge.com
gloves away from moving parts.
④
Do not operate the device while you are tired or under the influence of drugs,
alcohol or medication.
① Do not leave the device unattended for long.
② Do not make any modifications to the device.
③
To lower the build plate before loading/unloading filament. (The distance between
the nozzle and build plate should be kept for at least 50mm)
④
Operate the device in a well-ventilated environment.
⑤ Never use the device for illegal activities.
⑥ Never use the device to make any food storage vessels.
⑦
Never use the device to make any electrical appliance.
⑧ Never put the model into your mouth.
⑨
Do not remove the models with force.
· Environment Requirements
Temperature: RT 15-30℃
Moisture: 20%-70%
Do not abuse the filament. Please make sure you use the Flashforge filament or the
filament from the brands accepted by Flashforge.
All polymers degrade with time. Do not unpack until filament is needed. Filament
should be stored at clean and dry conditions.
To Next Page
Loading...
