————————————————————————————————————————————
Method 4: Click [File] --[Examples] to load the example files
Method 5: Click [File] --[Recent Files] to load the files opened recently.
Method 6: Select and drag the target file to the icon of FlashPrint.
Files with extension .STL, .OBJ, and .FPP, are supported by FlashPrint for editing.
View
Set View
Allows users to view the object on the build plate. Six views are under the view menu, that is,
home view, bottom view, top view, front view, back view, left view and right view.
Method 1: Click the [View] menu, there are six views in the drop- down list
Method 2: Click the [View] icon on the left, click it again and a submenu will appear with six
views for selecting.
Reset View
Allow users to reset views by the following two methods:
Method 1: Click the [View] menu and select [Home View]
Method 2: Click the [View] icon on the left, click it again and you will see the viewing options, you
can click [Reset].
Show Model Outline
Click [View] menu--[Show Model Outline], it will highlight the yellow border of the object
Show Steep Overhang
Click [View] menu--[Show Steep Overhang]. When the intersection angle between the model
surface and horizontal line is within the overhang threshold value, the surface has steep
overhang and it becomes red in the software. Overhang threshold value could be set as needed.
The default value is 45 degree.
To Next Page
Loading...
