Flashforge Finder - Page 14

Finder User Guide | www.ff3dp.com
14
Tools in print interface
◆Filament: To change filament during
printing.
(Note: You need to suspend the operation
first)
◆Finish-Shut: To start auto shutdown
◆Cancel: To end the tool orders and return
to the print interface.
Preheat
Tap the [Preheat] button to enter the preheat
interface. Tap the [Start] button to heat up to
the setting temperature.
The default temperature is 230℃.
Tap the temperature display bar to set the
temperature.
To set the preheat temperature.
Tap [Yes] to save the setting while tap [No]
to cancel the setting.