Flashforge Finder - Page 15

Finder User Guide | www.ff3dp.com
15
The picture displays the preheat interface. It
shows the actual temperature and the target
temperature. Tap the [Cancel] button to
abort the preheat job.
Tools
Tap [Tools] to enter tool options.
◆
Filament: To load/unload the filament.
◆
Level: To adjust the build plate.
◆
Home: To make the X, Y and Z axes back
to the zero point.
◆
Manual: To manually adjust the positions
of X, Y and Z axes.
◆
Setting: To implement relevant function
setups.
◆
Status: The check the real-time status of
the printer.
◆
About: Information about the printer.
◆
Return arrow
Manual adjustment
◆
Y+: The extruder moves to the zero point,
that is, the back of the machine
◆
Y-: The extruder moves to the direction
opposite to the Y+.
◆
X+: The extruder moves to the zero
points, that is, to the right direction
◆
X-: The extruder moves to the direction
opposite to the X+.
◆
Z+: The build plate elevates.
◆
Z-: The build plate descends.
◆
Return arrow