Flashforge Finder - Page 16

Finder User Guide | www.ff3dp.com
16
Tap [Setting] to enter the setting interface
◆
Language: To set the display language
◆
TP Adjust: Adjust the touch screen
◆
WIFI: To turn on/down the WIFI
◆
Servo on: To turn on/down the servo
◆
Printhead Adjust: To adjust the initial
distance between the extruder and the build
plate
◆
Filament Check Off: To turn on/off the
filament check
◆
Return arrow
TP Adjust
To tap the “+” on the touch screen to adjust
the touch screen.
WIFI:
◆Reset: Reset the WIFI
◆Turn on WIFI: Turn on the WIFI, release
the WIFI hotspot and set the WIFI on
computer
◆Return arrow
Printhead Adjust:
After the build plate and extruder finish
the initial movement, you can tap ‘+’or
‘-’ to adjust the distance between the
build plate and nozzle. Z：0. 00 stands
for the position where the servo is
precisely triggered.