Flashforge Finder - Software Menus

Finder User Guide | www.ff3dp.com
46
filament at a certain point.
(5-7) Click[Edit], then you can add or remove a height.
5.1.11 File Menus
①New Project
Click [File]--[New Project] can build a blank project. If there is an unsaved
modification on previous project, then will inform you whether the modification
needs to be saved or not. Click [Yes] will save the modification , click [No] will
abandon it. If click [Cancel] or close tool tip, then will cancel the new project.
②Saving
After finishing the model edit and adjustment, there are two ways below to save all
models in the scene.
Method 1:
Click [File]--[Save Project] in the menu bar, can save the file as a project file which
5-7